Hydraulic crimping machine KM-91C-6 is best choice for crimping 1/8" to 2inch 6SP hydraulic hose based on max opening(125mm), high force(6400KN) and steady quality.
1.Techincal Data of KM-91C-6:
| Crimp range |
1/8''-2.5'' |
| For hydraulic hose |
2.5inch 4SP/ 64mm 4SP |
| Max opening without dies |
125mm |
| Opening |
28mm |
| Force |
640T |
| Cycle time |
7s |
| Voltage & Power |
380V-50HZ-3PH |
| Optional voltage |
220V,240V,440V |
| Pump |
Piston pump 14.5min/L |
| Dies sets |
10 |
| System pressure |
30Mpa |
| Machine size |
800*635*1376mm |
| Weight without oil |
310KG |
| |
|
2. Hose Crimping Machine KM-91C-6 Dies:
Note: Die bore&Length can customized as your hydraulic fitting & ferrule size.
3. Hose Crimping Machine KM-91C-6 Special:
NEW foam inserts introduced to protect your machine from debris dropping into
the bottom of the head. With there you will minimize the risk of debris getting
into the cylinder which could cause damage to seals and other moving parts of
the head. This will significantly extend the life of hydraulic hose crimping machine.
4. Hose Crimping Machine KM-91C-6 Application:
1. Suitable for high precision pressing of low and high pressure hose diameter ,starting from 1/8" to 2" internal hose pipe.
2.
Use rubber hose to transmit hydraulic pressure as their working power.
3.
Used in Building Construction, Petroleum Industry, Chemical Industry, Car and Motor Industry.
Well, so many suppliers, why you should choose us?
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
1.Kangmai hose crimping machine CE& ISO PATENT Approved and SGS Audited.1/4
2.The fitting and hoses crimped by kangmai machine never leakage the oil and never broken.The reason like below:
(a)The machine head process by CNC machine,roundness and taper is within 0.1mm.
(b)The machine die base and dies adopt special die steel and process by advanced craft, the hardness is above 55 HRC.The die hardness is enough so that the die life is very long and easy to crimping high pressure hydraulic hose, 4SP even 6SP.
(c) The technical of machine head is forging or casting.Casting is cheap but has small hole on machine head.The piston will divide from casting machine head.
3.Strictly testing and inspetion.
(A) for raw material, we will check again by our inspector as per international standard.Only the raw material reach to international standard and allow enter kangmai facotry.
(B) for hydraulic and eletrical parts, such as valve, pump, motor and so on, we use famous brand both from China and abroad.However, we will check again when these parts enter our facotry.
(C) before the hose crimping machine enter our warehouse, the inspector check the machine roundess, taper, opening, speed, noise, apprance and so on.Only each parts is up to standard of ISO, CE standard, the machine can enter the warehouse.
(D) when the machine package, the inspector the dies, the package and other parts of clients requriment.Everything is ok, the inspector signed and machine allow to go out the facotry.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Audited Supplier 
){kind=link}
){kind=link}